SE Electronics R1-RIBBON R1 Dynamic Ribbon Mic w/shockmount

1.8 Micron pure aluminum ribbon element Large ribbon geometry design Rare Earth Neodymium Magnet VOX – Velocity Optimized Extension for superior sensitivity / output Custom design shock-mount Aluminum flight case Warranty includes 3 Ribbon replacementsThe R1 brings the advantages of the smooth classic sound of a high quality hand crafted Ribbon microphone within the reach of more users.Recommended for: Electric Guitar, Overhead Drum micing, Brass Instruments, Vocals, Horn Sections, Woodwind Instruments, String Sections, Broadcast.Operating Principle: Electrodynamic pressure gradient (velocity Microphone) Polar Pattern: Figure-8 Transducer Element 1.8-micron aluminum ribbon - 45mm/1.77" tall, 4.5mm/.177" wide Magnets Rare Earth Neodymiu Frequency Response m30 -15,000 Hz +/- 3dB Output Sensitivity > -52 dBv Re. 1v/pa Output Impedance: 300 Ohms Rated Load Impedance 300 Ohms Maximum SPL >135dB over rated frequency response (more over 1K...) Powering Not needed or recommended. Tolerant of properly wired phantom power through a good cable. Output Connector Male XLR 3 pin Dimensions 168mm L, 40mm W Weight 450g Finish Mesh grille: satin nickel, Body: matte gray Warranty 5 years, 3 ribbon replacements